T&C retrain wheel sensors

[Zork]

Is it necessary to go to the dealer to retrain the tire sensors
on my '03 T&C ? When I get to the option on the console and it
comes up with the first tire to retrain, I can't seem to get
any further.
Thanks !
Zork

 

[Bill]

Use must put a strong round magnet with a hole in the middle of it (dealer
uses a special tool but it's still a magnet) over the metal valve stem to
close the reed switch to get the sensor to transmit it's ID to the overhead
console. This is done in sequence as dictated by the overhead console. The
horn will chirp to acknowledge receipt of the ID and then you go to the next
indicated tire. If you are too slow the system times out and aborts.

Bill

 

[mic canic]

read the owners manual
you need a round magnet with a hole in the center to retrain the
sensors
place magnet over valve core