Spark Plug Replacement

Discussion in 'General Motoring' started by Bob Snyder, Oct 7, 2004.

  1. Bob Snyder

    Bob Snyder Guest

    Okay, how do I get the rubber boots out to replace teh spark plugs on my '03
    Dodge Neon? I suspect the same issue exists with the PT Cruiser, right?
     
    Bob Snyder, Oct 7, 2004
    #1
  2. Bob Snyder

    Richard Guest

    Careful turn them first. If you pull they will break!

    Richard.
     
    Richard, Oct 7, 2004
    #2
  3. Bob Snyder

    Tom & Debbie Heintz Guest

    Put some silicone on the inside of the new wire boots, they'll come off
    easier & it'll also help seal moisture out.
     
    Tom & Debbie Heintz, Oct 7, 2004
    #3
  4. Bob Snyder

    Rudy Allemann Guest

    Rudy Allemann: I had a '92 Caravan and the method I used to remove
    the rear wires was to make a double loop of twine around the wire and
    drop it down till it was near the plug. Then pull up gently such that
    it binds on the wire and then pull till the wire/boot comes off the
    plug. I need this method on only two plugs. Putting the boots back
    on the new plug was not difficult.
     
    Rudy Allemann, Oct 12, 2004
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Question on satisfactory spark plug cables for 3.5L

  2. how to figure out colt spark plug order

  3. 1999 Caravan 3.0 Spark plug

  4. spark plug replacement on V6

  5. Spark Plug Replacement, 99 Voyager

  6. 1997 LHS spark plug wire replacement

  7. 1997 LHS spark plug wire replacement - followup

Loading...