removing the dash of 2001 dodge neon

Discussion in 'Neon' started by grave_for_you, Oct 13, 2005.

  1. grave_for_you

    grave_for_you Guest

    can anyone help me with this? i want to remove the top part of my dash
    but i can't figure out what is holding it down. i got the screws on the
    driver and passanger sides and when i lift up on it, something behind
    the gauges is holding it from coming off. if anyone knows how to remove
    it, and could tell me, i would greatly appreciate it. i've repainted
    most of my dash, and this last part i would really like to paint but,
    lol, i just can't figure it out!
    thanks again,

    dan
     
    grave_for_you, Oct 13, 2005
    #1
  2. grave_for_you

    David Guest

    It might be the same as my Sebring. Make sure all the visible screws are
    removed. Take out the center panel were the radio and heater are to make
    sure. and also the left by the fuse panel cover, remove the cover and check
    for some screws. and you should pull it towards you to have the clips
    disengage.
     
    David, Oct 13, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to replace lights of the speedometer behind the dash?

  2. Removing side moldings from Dodge Spirit

  3. 1996 Dodge Intrepid makes a rattling noise under the dash

  4. 2001 dodge neon transmission

  5. Removing the rear bumper / fender on a UK 99 Voyager

  6. !995 neon keeps blowing the A/C 10 amp fuse in the engine compartment fuse

  7. How do I go about removing the driver door from a 1994 LeBaron convertible?

  8. Sebring 2,7 LX 2001 gauge illumination (dash light)

Loading...