Rear Door Panel Removal - 2000 Concorde LXi

Manual states: "Using a trim tool, disengage the retainer clips from the
door trim panel to the door panel." I don't know which tool to use or how to
use it (wedge it in, tip to pop the clip up, push it, hook something inside
and pull it?)

I have a tool that looks like the 3rd one pictured in the link given below;
"door upholstery remover". Two frames above that is a picture of 5 tools in
a panel removal kit that are much latter.
http://www.jcwhitney.com/Chrysler-Conquest-Car-Interior-Tools/200730798-600017978.jcw

Which of these tools do I need? Can someone give me some guidance on what to
expect in removing the panel (how to use the tool).

 

Yes - that's the one. Called a trim popper. Also, any local auto parts
store will have that tool or the equivalent by a different manufacturer
- that's a generic tool.

Bill Putney
(To reply by e-mail, replace the last letter of the alphabet in my
address with the letter 'x')

 

Thanks, Bill. Then I assume I just slide the tool between the door frame and
upholsered door panel at the point of the clip (with the stem of the clip
centered between the progs of the tool) and pry it straight up by applying
pressure straight down on the tool handle. Correct?