grand cherokee alarm

Discussion in 'General Motoring' started by STEVEN SKIPPER, Jul 11, 2003.

  1. 95ZJ..GRAND CHEROKEE LMTD. How do you disable the factory alarm but keep
    the power
    door locks active. Apparently I have a wiring short somewhere in the body
    harness and I cant find it and it continually trips the alarm, and killing
    the battery.

    If any one can help plz re.

    Thanks from a former Jeep Dealer Employee
    STEVEN SKIPPER, Jul 11, 2003

    mic canic Guest

    first of all you can't
    check the hood pin switch for corrosion and with the alarm set, press down on
    the hood in the switch area if it goes off the switch is bad
    the other thing that needs checking is the disarm switches attached to the
    door lock cylinders and you do that by setting the alarm and using the door
    locks to open the doors and turn off the alarm if one doesn't turn off the
    alarm then thats a bad switch and there is a good chance it's causing a
    battery draw to boot
    mic canic, Jul 11, 2003

    Galen Guest

    previous experience I found that the disarm switch, built into the front
    door key cylinder is shorted and causing you a problem, check this
    before doing any expensive, uneccessary repairs
    Galen, Jul 13, 2003
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.