Engine oil leak and P/S pump pulley - 92 Dynasty, 3.3L

Discussion in 'General Motoring' started by Thomas Sajnovic, Jul 20, 2005.

  1. Two questions
    Chrysler Dynasty 1992, 3.3L

    1)Engine oil leak - Over the past couple months I've notice a leak (thats
    getting worst) from the engine. It isnt coming from the heads or head
    covers, so it isnt a gasket or leak from the top of the engine. I have
    changed out the oilpan gasket as it looked the leak was originating from
    there. After the gasket was changed, the leak continued and would come out
    from around where the bell housing and engine would meet. The flywheel is
    dry, so I would assume it would not be a main crank seal at the rear of the
    engine. Any ideas as to where this leak could be coming from?

    2) Power Steering pump pulley - Has anyone ever had to get a pulley changed
    out on this pump? I changed out the water pump last weekend and since the
    belt was off, I noticed the power steering pump pulley was loose on the pump
    shaft. I also noticed that it was plastic, and would account for it to
    wobble on the shaft due to wear. Have these always come with plastic
    pulleys, or is there a metal pulley you can get for it?

    Thanks,
    Tom
     
    Thomas Sajnovic, Jul 20, 2005
    #1
  2. Thomas Sajnovic

    kmatheson Guest

    I once had a leak from the timing case on my 3.3, that appeared as
    though it was coming from the oil pan. It took the dealer three tries
    to figure it out. Luckily, the warranty covered it.

    -Kirk
     
    kmatheson, Jul 20, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.