Drive belt 3.3

Discussion in 'General Motoring' started by DanFXR, Mar 31, 2007.

  1. DanFXR

    DanFXR Guest

    2002 T & C, 3.3.

    I just replaced the water pump and installed a new belt tensioner. I am
    having a problem getting the new belt on.
    The new tenioner (OEM Part) does not have a slot for a wrench on the
    front side to release the tension like the original . It has a spot for a
    1/2 inch breaker bar however the bar won't fit between the frame and unit.
    Is there a tool made just for this? Any one have another method?
    Thanks,
     
    DanFXR, Mar 31, 2007
    #1
  2. DanFXR

    kmatheson Guest

    Hmmm. I just did the one on my 1993 last week. Used my 3/8" breaker
    bar with a 15mm socket on the nut in the center of the pulley. I hope
    that was the correct way. It seemed to work okay, and I couldn't see
    any other way to do it.

    -KM
     
    kmatheson, Apr 1, 2007
    #2
  3. DanFXR

    DanFXR Guest

    Thanks I will try that ,thats how I used to do my pontiac I was just not
    sure if it was ok to move it like that, I'm sure it is.
     
    DanFXR, Apr 1, 2007
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. '03 Cherokee 2 wheel drive differential-update

  2. cv joint / boot for rearWheel drive colt??

  3. Removal of Drive window & Door handle Shadow

  4. 2.5 voyager stalls after 30 mins drive and temp goes up

  5. Why Won't My 93 Caravan Go Into Drive?

  6. drive belt replacement

  7. PT Cruiser drive belt replacement

  8. 95 Wrangler 4 wheel drive/lack of 4 wheel drive problem

Loading...