Door frame seals (300m) - comes off, too short - fix?

Discussion in 'Chrysler 300' started by MoPar Man, Jul 22, 2005.

  1. MoPar Man

    MoPar Man Guest

    The rear door seals on my 2000 300M (the combination plastic/rubber)
    strip that runs up the front edge, across the top, and down the back
    edge seems to only be held in place by a friction fit (no glue or
    screws) and the fit isin't great (it's too short and doesn't follow
    the corners). Maybe the front foor seals have the same problem.

    Anyways, what's the fix for this? Stretch the hell out of it and use
    contact cement?

    Does Chrysler have a better fitting seal kit? Aftermarket?
     
    MoPar Man, Jul 22, 2005
    #1
  2. MoPar Man

    Art Guest

    The fix is to buy one. Cut the others and leave the cut edges at the bottom
    and fille them in with a piece of the new one. At the bottome everything
    can be held by trim even though cut and spliced.
     
    Art, Jul 22, 2005
    #2
  3. MoPar Man

    TNKEV Guest

    Chrysler does have a small metal clip that goes inside the weather
    strip PN# 5019585AA use it and some good weather strip adhesive.
     
    TNKEV, Jul 23, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 300M A/C pressures way too high (solution)

  2. How do you fix the rear windshield wiper, it turns itself on and off.

  3. 42LE tranny: Bad short shaft bearing - possible easy fix (adjuster)?

  4. Installing Oil Seals the Proper Method

  5. Brand Breakdown: Too Many Models, Too Little Innovation Destroyed Detroit's Customer Loyalty

  6. LHS Sub Frame question

  7. fuel injector seals

  8. cirrus plug seals & distributor

Loading...