AC, rear window everything control

Discussion in 'General Motoring' started by L.G.R., Oct 6, 2007.

  1. L.G.R.

    L.G.R. Guest

    Hi everyone.
    Could someone explaines to me again how to re-program the AC, rear window
    defrost, rear window wash and rear whiper on a 98 Voyager?
    I have those two lights blinking all the time and nothing work properly and
    i see
    winter comming. I have tried pressing AC and rear window washer for 5
    seconds as I been told
    to do before on this forum and all the lights on the buttons start flashing
    but after few minutes the same two lights start blinking as before.
    Should I do better in changing the whole control with an other used one?
    Thank you.
    L.G.R.
     
    L.G.R., Oct 6, 2007
    #1
  2. L.G.R.

    philthy Guest

    those lites blink in a certain sequence when the module detects a fault code
    and proper operation ceases when a fault is recorded untill the proper repair
    is done.
    this is on board diagonistics
    if t this is occuring to you, a factory service manual spells out the flashing
    sequences and decifer fualt codes accordingly
    the engine should be running at op.temp before system is retrained
    the temp levers should be in the coldest settings and blower should be at full

    press the botton left button at the same time as u pres the top left button and
    hold both down untill they start flashing then let up and let the system do
    what it does and go from there if the same 2 buttons u pressed are flashing at
    the end all is good shut off van and restart it and see what happens
     
    philthy, Oct 7, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.