96 Town & Country Oxygen Sensor

Discussion in 'General Motoring' started by techdrive, Oct 21, 2004.

  1. techdrive

    techdrive Guest

    I need to change my upper (manifold) O2 sensor and I can just see it from
    under the vehicle way up on top of the rear manifold. Anyone have any
    proceedures for getting to it? It looks like I need to drop the engine or
    something drastic like that to get to it. Help!
     
    techdrive, Oct 21, 2004
    #1
  2. techdrive

    maxpower Guest

    Before dropping the engine......take it to a shop and ask them to get it
    off, its easier to raise the vehicle then pull the engine
    Glenn Beasley
    Chrysler Tech
     
    maxpower, Oct 21, 2004
    #2
  3. techdrive

    techdrive Guest

    Do you know a proceedure? I was hoping to keep out of the shop if possible
    sparing funds. Thanks
     
    techdrive, Oct 22, 2004
    #3
  4. techdrive

    maxpower Guest

    well you never did say what engine it has?? if its the 3.3/3.8 with a
    specail wrench you may be able to get it from the top,
     
    maxpower, Oct 22, 2004
    #4
  5. techdrive

    techdrive Guest

    Thanks, It is the 3.8, forgot to mention that.
     
    techdrive, Oct 22, 2004
    #5
  6. techdrive

    mic canic Guest

    if you have a new one then cut the wires off at the sensor so u can use
    a regular socket to remove it from underneath just jack it up
     
    mic canic, Oct 23, 2004
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.