96' Town and Country - PCM Problems

[Mark Tise]

Hello,

I have had my PCM replaced twice in the last two weeks. The first was a defective part shipped from Newark, NJ to a dealer in Delaware (what a way to spend a vacation). In between the PCM replacements the Map Sensor, Cam Sensor and a third sensor went bad. The dealership said they can not link the sensors blowing out to the faulty PCM, and the Chrysler Customer Service just called the dealership to discuss the problem with them, but will not claim responsibility. It is unfortunate that one just confirms the other! It may not be common sense to anyone else, but the faulty PCM shorted out the three sensors.

Mark

 

[sackiss]

maybe it was one of the three sensors that was your original problem and not the pcm?
bryan

 

[mic canic]

i would be looking at a engine harness issue on the year van

Mark Tise wrote:

Hello,

I have had my PCM replaced twice in the last two weeks. The first was a defective part shipped from Newark, NJ to a dealer in Delaware (what a way to spend a vacation). In between the PCM replacements the Map Sensor, Cam Sensor and a third sensor went bad. The dealership said they can not link the sensors blowing out to the faulty PCM, and the Chrysler Customer Service just called the dealership to discuss the problem with them, but will not claim responsibility. It is unfortunate that one just confirms the other! It may not be common sense to anyone else, but the faulty PCM shorted out the three sensors.
...