95 Wrangler 4 wheel drive/lack of 4 wheel drive problem

Discussion in 'General Motoring' started by a316co2000, Jan 16, 2008.

  1. a316co2000

    a316co2000 Guest

    Ok so I made the mistake of romping around in the middle of the
    desert, at night, in an area I was unfamiliar with, and I did some
    damage to my 95 YJ. In short, I had to replace the front driver's
    side leaf spring, which, in it's bending, pushed the front drive
    shaft
    back into the transfer case, breaking the case in half. So I
    replaced
    the transfer case too, and chose to go with a used one with a slip
    yoke eliminator. I had a new rear drive shaft built that is
    compatible with the new transfer case.

    After hooking everything back up, and adding fluid to the transfer
    case, my 4 wheel drive shifter will not lock into place. Also, when
    I'm in 2 wheel drive the 4 wheel light comes on, but I don't think 4
    wheel is actually engaged. When I shift to 4 high or 4 low, the jeep
    acts like it's in neutral and won't move, and the 4 wheel light goes
    out.


    Does anyone know what might be wrong with my YJ?
     
    a316co2000, Jan 16, 2008
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.