'95 LHS Turn Signal/Hazards dead after tranny rebuild

Discussion in 'General Motoring' started by SNaXX, Dec 18, 2003.

  1. SNaXX

    SNaXX Guest

    Hello.

    I just recently had my transmission rebuilt after it went out. When I got
    the car back from the repairman, I noticed that my turn signals and hazards
    are completely dead. I called them up and he said they didn't do anything
    that should have caused it. So I don't know if it's just a coincidence that
    the flasher burnt completely out or not at that point.

    I'm wondering if any of you know of anything they may have touched outside
    of the car when replacing the transmission to cause the problem. Everything
    else seems to work ok. Just no hazards or turn signals. I haven't had a
    chance yet to check the flasher.

    Thanks for any input.
     
    SNaXX, Dec 18, 2003
    #1
  2. SNaXX

    mic canic Guest

    make sure the 2. 16 gauge wires are still connected to the + battery cable
     
    mic canic, Dec 18, 2003
    #2
  3. SNaXX

    Art Begun Guest

    I'd tell them to get their rear ends over and look at what they
    screwed up. Your going to tell me that they didn't test drive the car
    long enuf to hit the turn signals once???? Give me a break.
     
    Art Begun, Dec 18, 2003
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.