95 Concorde stalls when hit a bump

Discussion in 'Concorde' started by braevan, Jul 27, 2003.

  1. braevan

    braevan Guest

    I have a 95 Concorde, which stalls on occasion when I hit a bump. It
    will stall out, but when I try and restart it, it will not start. I have
    to turn the ignition off for a few seconds, then it restarts and runs fine.
     
    braevan, Jul 27, 2003
    #1
  2. braevan

    Bscuda Guest

    Do any lights come on?

    When I first bought my Vision, the crank shaft position sensor was causing
    the engine to turn off but everything else was still functioning normally
    including the cruise. The sensor is pretty cheap and only one bolt holds it
    on. If your a contortionist, you can even change it without jacking the car.
    I would change it anyway.

    Bob
     
    Bscuda, Jul 31, 2003
    #2
  3. braevan

    Frans de Wet Guest

    With mine the actual connector that connects the crank shaft position
    sensor to the wiring was bad. HARD to find ...
     
    Frans de Wet, Jul 1, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 97 Voyager 3.0l stalls when cold

  2. 1993 Plymouth Grand Voyager 3.3 - Stalls when hot

  3. car stalls when going to stop

  4. '92 spirit stalls when cold starting, runs great when warmed up

  5. 1994 Sundance stalls/runs rough when cold

  6. The 300C Touring could be a hit in the UK - with diesel engine

  7. dead sundance and duster after going over a bump

  8. Can Chrysler hit jackpot again?

Loading...