94 Concorde Power Antenna

Discussion in 'Concorde' started by Jan, Mar 21, 2005.

  1. Jan

    Jan Guest

    My sister has a 94 Concorde with power antenna that will not move up or
    down. Her husband bought a new antenna however can't figure out how to
    install it. Anyone with advice, TIA.
     
    Jan, Mar 21, 2005
    #1
  2. Jan

    maxpower Guest

    If its a Mopar part, it is very simple to do, should only take 5 min......I
    wouldnt think an after market part would be any harder.
     
    maxpower, Mar 21, 2005
    #2
  3. Jan

    Bob Shuman Guest

    This assumes there is not much of the broken tail stuck in the motor and you
    can replace it from the top without removing and opening it up.

    Bob
     
    Bob Shuman, Mar 21, 2005
    #3
  4. Jan

    maxpower Guest

    I assumed that if the antenna didnt go up or down they were replacing the
    motor assembly? Not the antenna mask kit. If the motor is bad it wouldnt
    pull the new part either,
     
    maxpower, Mar 21, 2005
    #4
  5. Jan

    Bob Shuman Guest

    I assumed it was just the mast as from my experience the motor usually works
    fine and the nylon toothed rack is what breaks from years of use. In
    looking back, the OP was not clear. Either way it isn't too bad a job.
    Sometimes you get lucky and don't need to remove the motor. That was what I
    thought you were referencing as the "5 minute" job.

    Bob
     
    Bob Shuman, Mar 22, 2005
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.