1994 3.3L Intrepid will not start

Discussion in 'General Motoring' started by Rick_T, Aug 11, 2008.

  1. Rick_T

    Rick_T Guest

    I have a difficult no-start problem on a 1994 Dodge Intrepid 3.3L.
    Any suggestions would be appreciated.
    As reported to me, the car was running when the engine suddenly died;
    then no-start.
    So far:
    No codes
    No check engine light at all, even during the initial seconds after
    the key is put into the on position
    No spark
    Cam and crank sensors check out good
    Coil pack measures good (resistance), no power going to it
    No power (8V) to the cam and crank sensors from the PCM, no power to
    the coil pack from the PCM
    ASD relay and fuel pump relay do not energize when the key is put in
    the “on” position.
    12V is through the ASD and FP relays in the power distribution block
    (engine left side) and goes into terminal 51 of the PCM but they don’t
    energize.
    Engine does crank but no start
    Removed all sensor plugs to see if 8V output would come from PCM, it
    did not.
    All fuses are good
    Measured 47 ohms to ground on all PCM lines that run to ground
    Replaced PCM, no change


    Regards,

    Rick
     
    Rick_T, Aug 11, 2008
    #1
  2. Rick_T

    aarcuda69062 Guest

    Do you have 12 volts at PCM pin #3 from the battery?

    Do you have 12 volts at PCM pin #9 with the ignition turned on?
     
    aarcuda69062, Aug 11, 2008
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.