1989 Chrysler New Yorker chokes out

Discussion in 'Other Models' started by Alex, Mar 19, 2016.

  1. Alex

    Alex

    Joined:
    Mar 19, 2016
    Messages:
    1
    Likes Received:
    0
    1989 Chrysler New Yorker
    Replaced fuel pump, plugs wires, coil, distributor, fuel filter The engine was changed before I got it with a 3.0L from an 88 Dynasty. The wires on cylinders 3 and 5 were reversed and it ran like this for some time. The issue i am having with it is When it has been running and fully warmed it "It wont start" It will fire and stop. After multiple attempts it will start with the gas petal too the floor. Sounds like it can't breath. Will sputter and pit then finally rev up. Since it sat all winter it will idle rough until warmed up.

    Could this be a MAP sensor problem? I have cleaned the throttle body out and the fuel is not old in it. The oil sending unit is defective but oil pressure is fine " had it checked"

    Any suggestions would be appreciated.
     
    Alex, Mar 19, 2016
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 1989 chrylser new yorker no start

  2. HELP! 1989 chrysler new yorker prob!!!

  3. 1989 new yorker wont re-start when hot

  4. Chrysler 300M chokes.

  5. Weird problem (1989 Chrysler New Yorker V-6)

  6. 1989 New Yorker water pump.

  7. 1989 Chrysler New Yorker Mark Cross Edition - leather roof

  8. Curt trailer hitch #12025

Loading...