96 Chrysler Town and Country PCM---Wont Start

Discussion in 'General Motoring' started by Shalicody, Jul 9, 2004.

  1. Shalicody

    Shalicody Guest

    HELP!! I have a 96 Chysler Town and Country. Broke the Front drivers side
    drive shaft on
    Thursday. I replaced the part on Monday. Took the van around the block
    for a test drive and it stalled. Now it will not start. Put it on the
    computer and it is not throwing any codes. Replaced the coil pack and
    put
    in new spark plugs. It will not fire unless the battery is almost drained.
    I have checked all ground wires, and fuses...everything is fine. Possible
    PCM?
    Anyone have any ideas?
    Please email me, in desperate need of my van. I have a handicapped child
    and its the only vehicle that is wheelchair accesible. Please email me at


    Thanks
     
    Shalicody, Jul 9, 2004
    #1
  2. Shalicody

    mic canic Guest

    did you check all the fuses what about a cut crank sensor wire
     
    mic canic, Jul 10, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 96' Town and Country - PCM Problems

  2. '03 Town and Country ABS and Floor mat question.

  3. 96 T&C Wont Start

  4. ECU/ PCM engine computer for '95 Chrysler Town & Country van

  5. 1999 town&country wont start

  6. 2004 3.3 Town and Country. Engine runs rough and stalls after filling gas.

Loading...